Hello all,
Setup:
Truenas Core latest
1 x WD Black 250GB drive as boot-pool
3 x WD Red 4TB as storage
1 x WD Red 10TB (new replacement drive)
It took its time but after 7 years a drive within my RAIDZ1 pool died.
Truenas faulted the drive which I understand means it was removed from the pool. It was one of 4 x 4TB drives.
In the mindset of replacing and trying to expand my pool, I got a WD Red 10TB on sale to replace it with.
I physically removed the faulted drive and put in the 10TB drive and ran the "replace disk" via the GUI, it worked fine and replaced the drive but.. I don't see any more storage.
The pool had 4TB free space when I removed the faulted drive, so in my mind I should have more than that now a 10TB has replaced it.
Is there a GUI way or CLI command I can use to get that extra space in?
Autoexpand is turned on.
Any help would be great.
Thanks.
Setup:
Truenas Core latest
1 x WD Black 250GB drive as boot-pool
3 x WD Red 4TB as storage
1 x WD Red 10TB (new replacement drive)
It took its time but after 7 years a drive within my RAIDZ1 pool died.
Truenas faulted the drive which I understand means it was removed from the pool. It was one of 4 x 4TB drives.
In the mindset of replacing and trying to expand my pool, I got a WD Red 10TB on sale to replace it with.
I physically removed the faulted drive and put in the 10TB drive and ran the "replace disk" via the GUI, it worked fine and replaced the drive but.. I don't see any more storage.
The pool had 4TB free space when I removed the faulted drive, so in my mind I should have more than that now a 10TB has replaced it.
Is there a GUI way or CLI command I can use to get that extra space in?
Autoexpand is turned on.
Any help would be great.
Thanks.