Hello to everyone!
I have a question about replication, specifically about visibility of replicated snapshots on destination system.
I have set-up a replication of four datasets from my production system, one of which has 4 four sub-datasets.
Replication was configured as recursive.
After first replication (manual) I could see all replicated datasets (and sub-datasets) and their contents, and list them in shell (ls), but after second replication (automatic, zero size) all sub-datasets are not listed in shell, but datasets without child datasets are populated.
Snapshots in Storage menu shows sub-datasets with referenced size (which is correct).
I should mention that both freenas systems run the same version 11.3 - stable (updated).
I gather that data is replicated correctly, but visibility is misconfigured or I have wrong expectations about how it works.
Thanks to anyone can educate a novice...
I have a question about replication, specifically about visibility of replicated snapshots on destination system.
I have set-up a replication of four datasets from my production system, one of which has 4 four sub-datasets.
Replication was configured as recursive.
After first replication (manual) I could see all replicated datasets (and sub-datasets) and their contents, and list them in shell (ls), but after second replication (automatic, zero size) all sub-datasets are not listed in shell, but datasets without child datasets are populated.
Snapshots in Storage menu shows sub-datasets with referenced size (which is correct).
I should mention that both freenas systems run the same version 11.3 - stable (updated).
I gather that data is replicated correctly, but visibility is misconfigured or I have wrong expectations about how it works.
Thanks to anyone can educate a novice...
