DaPlumber
Patron
- Joined
- May 21, 2014
- Messages
- 246
This is driving me up the wall:
I have a bunch of snapshots on datasets that were replicated to another (in this case local) pool by selecting the recursive option on the base dataset in both cases. Now I don't want to snapshot or replicate all the datasets in the pool, so each dataset has it's own snapshot and replication job in the GUI. The snapshots are continuing just fine, but the replication is error-ing out complaining about the existing snapshots. Sure I could "initialize" the destination and wipe everything out and start over, but I don't want to do THAT.
How on earth do I get replication to continue with existing valid snapshots?
I know how I'd do this on the CLI and snapshots have "serial numbers" and inheritance so it should "just work", but I'm trying to be a good boy and not go behind the GUI's back...
I have a bunch of snapshots on datasets that were replicated to another (in this case local) pool by selecting the recursive option on the base dataset in both cases. Now I don't want to snapshot or replicate all the datasets in the pool, so each dataset has it's own snapshot and replication job in the GUI. The snapshots are continuing just fine, but the replication is error-ing out complaining about the existing snapshots. Sure I could "initialize" the destination and wipe everything out and start over, but I don't want to do THAT.
How on earth do I get replication to continue with existing valid snapshots?
I know how I'd do this on the CLI and snapshots have "serial numbers" and inheritance so it should "just work", but I'm trying to be a good boy and not go behind the GUI's back...