Jason Fayre
Dabbler
- Joined
- Apr 11, 2015
- Messages
- 18
Hello all,
I've recently been having a lot of trouble with my Freenas system. My original board which was a Asrock c2550d4i, failed after a year with what Asrock says was a faulty sensor on one of the power rails.
Asrock sent me another board, which was a c2750d4i. I ran this board for about a week, then started having trouble. The system would start rebooting itself every 5-10 minutes. After I discovered this, I shut down the system and attempted to cold boot it. The system would not come up at all. If I cut the power from the PSU switch on the back and then turned it back on, the fans and HDDs would start spinning up for about 3 seconds, then immediately power down. Nothing I did would get the system to power up.
I could access the BMC, and noticed several mentions of the CPU going into high temperature.
Asrock is now sending me another board, which will be the c2550 that they should have replaced mine with in the first place.
Has anyone seen behavior like this on these boards? My system has now been out of service since the middle of June.
My case is a silverstone ds380.
c
I've recently been having a lot of trouble with my Freenas system. My original board which was a Asrock c2550d4i, failed after a year with what Asrock says was a faulty sensor on one of the power rails.
Asrock sent me another board, which was a c2750d4i. I ran this board for about a week, then started having trouble. The system would start rebooting itself every 5-10 minutes. After I discovered this, I shut down the system and attempted to cold boot it. The system would not come up at all. If I cut the power from the PSU switch on the back and then turned it back on, the fans and HDDs would start spinning up for about 3 seconds, then immediately power down. Nothing I did would get the system to power up.
I could access the BMC, and noticed several mentions of the CPU going into high temperature.
Asrock is now sending me another board, which will be the c2550 that they should have replaced mine with in the first place.
Has anyone seen behavior like this on these boards? My system has now been out of service since the middle of June.
My case is a silverstone ds380.
c