I have a HP DL320e where I've put in a WD Black PCIe nvme card.
Apparently the Hp will not boot from this card, despite that it sees it as a mass storage card, and it has been set as first boot controller.
So I was thinking about using a USB for doing the initial boot, and then remap everything to the NVME PCI card, but is there a guide somewhere on how to do that?
I do have four hot-swap ports in the front, and I currently have 2 12 TB WD Black drives, and I have two more, so I could of course mount the two 500 GB drives previously placed there as boot drive, but then I don't have any way of expanding the storage :-(
I beleive the best solution for us would be to have it 'bounce' of the USB drive, and then boot on the NVMe card.
Apparently the Hp will not boot from this card, despite that it sees it as a mass storage card, and it has been set as first boot controller.
So I was thinking about using a USB for doing the initial boot, and then remap everything to the NVME PCI card, but is there a guide somewhere on how to do that?
I do have four hot-swap ports in the front, and I currently have 2 12 TB WD Black drives, and I have two more, so I could of course mount the two 500 GB drives previously placed there as boot drive, but then I don't have any way of expanding the storage :-(
I beleive the best solution for us would be to have it 'bounce' of the USB drive, and then boot on the NVMe card.
