Hi Community, I am facing a funny issue at the moment. I am running FreeNAS: FreeNAS-11.3-U5.
I bought a used 10G PCI-E (Qlogic QLE8262L, dual SFP+) port.
Issue 1: the FreeNAS can only show a single SFP+ port under network. I understand it may need driver, not sure if any of you have tried.
Issue 2: I then removed the 10G card from my server. However, somehow, the network page is still showing that 10G port, and says no traffic. I have tried reboot FreeNAS, power off, and power on, but no luck. the none existent port still showing in network. see the picture attached. wondering if any of you have seen this issue before? Thank you.
Andy
I bought a used 10G PCI-E (Qlogic QLE8262L, dual SFP+) port.
Issue 1: the FreeNAS can only show a single SFP+ port under network. I understand it may need driver, not sure if any of you have tried.
Issue 2: I then removed the 10G card from my server. However, somehow, the network page is still showing that 10G port, and says no traffic. I have tried reboot FreeNAS, power off, and power on, but no luck. the none existent port still showing in network. see the picture attached. wondering if any of you have seen this issue before? Thank you.
Andy