New to FreeNAS. AHCI SSD, long delay before detection

[neominder]

So I'm having an issue where the system is not seeing my SSD until quite a while after boot. After a few minutes I can do camcontrol reset/rescan and then they show up in camcontrol devlist.

I don't know what info is needed to troubleshoot this.

These are the controllers I'm using as far as I can tell.

ahci1@pci0:0:31:2: class=0x010601 card=0xb0051458 chip=0x3b228086 rev=0x06 hdr=0x00
ahci0@pci0:2:0:0: class=0x010601 card=0xb0001458 chip=0x91281b4b rev=0x11 hdr=0x00
siis0@pci0:4:0:0: class=0x010600 card=0x31321095 chip=0x31321095 rev=0x01 hdr=0x00

The siis0 works fine. I don't know which of the other two has the SSDs on it.

These are the drives after they're detected via camcontrol reset/rescan.

scbus0 on ahcich0 bus 0:
<Corsair Force 3 SSD 1.3> at scbus0 target 0 lun 0 (ada7,pass10)
<> at scbus0 target -1 lun -1 ()
scbus1 on ahcich1 bus 0:
<Corsair Force 3 SSD 1.3> at scbus1 target 0 lun 0 (ada8,pass11)
<> at scbus1 target -1 lun -1 ()


So I'm not sure where to go from here, hoping someone can help me out.

Thanks!

 

[mav@]

It would be helpful if you provided full verbose boot messages. To get them you should boot with 'boot -v' from loader prompt.