Installed Dell H200 LSI 9210-8i drives not detected

[CoMb0BrEaKeR]

Hi. Just getting into a TrueNAS Scale setup. I just bought what should be a Dell H200 LSI 9210-8i flashed to IT mode https://www.ebay.com/itm/133117759343 but I connected some SATA SSD disks to it they do not show up as devices to add to a storage pool. Running TrueNAS Scale that was just recently setup. Where in TrueNas Scale can I find if the card is recognized and or if any of the attached disks? I have not used TrueNAS Scale before but all the SATA HDDs connected to the Motherboard SATA ports and NVME modules are recognized and was able to build a storage pool.

Thanks!

 

[artlessknave]

sudo mprutil show adapter

you should post your hardware to be compliant with the forum rules.

 

[CoMb0BrEaKeR]

Ok I will check that.

Ah I though I had added all that to my Sig

Gigabyte Vision D Z590 Motherboard
Intel i9 10900k
64GB Ram
Six 10TB Hitachi Ultrastar HUH721010ALN600 in 1 storage pool
Motherboard SATA
Motherboard Ethernet

 

[CoMb0BrEaKeR]

sudo mprutil show adapter

you should post your hardware to be compliant with the forum rules.

Looks like mprutil is not installed on the system. Where can I get that?

 

[Ericloewe]

For SAS2, it wouldn't be mpr anyway.

Try sas2flash -listall

 

[artlessknave]

For SAS3, it wouldn't be mpr anyway.

hmm. that's odd. that command is how I get the adapter info for my signature. from a sas3 card.

 

[Ericloewe]

Typo, I meant to say SAS2.

 

[artlessknave]

ah. right.
I use 2 commands depending on the controller
SAS2: sudo mpsutil show adapter
SAS3: sudo mprutil show adapter

they must not be present on SCALE. shame. convenient.