How to setup iSCSI properly?

Status
Not open for further replies.

HolyK

Ninja Turtle
Moderator
Joined
May 26, 2011
Messages
653
Hello,

can anyone please make a quick "HOWTO" for properly settings of ISCSI in FreeNAS 8 ?

I'm trying to setup it, but without success :/

Thanks
 

survive

Behold the Wumpus
Moderator
Joined
May 28, 2011
Messages
875

HolyK

Ninja Turtle
Moderator
Joined
May 26, 2011
Messages
653
Thanks, i must overlook this in wiki ... srry. Anyway, i followed the documentation, but i'm getting two errors:

1) When i add a new Target, i get this in console:
targeterror.png


My Settings:
targetset.png


2) When i add new Extend, i get this in console:
extadderr.png


My settings:
extset.png



And, when i trying discover/connect (to) created ISCSI, i get "Connection failed" msg


Thanks in advance for any help
 

ezteok

Cadet
Joined
Jun 13, 2011
Messages
7
Any luck? I had this to, it's just because you are allready fired up iscsi while you are still configuring the beast. You can ignore these cause these errors, they will disappear when you got your config right. Or stop iscsi while configuring of course :) But you missing a important section.... You must setup the option "Target / Extents" after you set up a extent and a target... Connect a target to a extent so to speak... In your case it will be 'test - test' so i would change to another target name if i was you...

J
 
Status
Not open for further replies.
Top