freenas can't see all hdd

[E_B]

Hi .
My motherboard is GA A75M S2V have 6 SATA 3 controllers config IDE ,
Controller 0 Master ,
Controller 0 Slave ,
Controller 1 Master ,
Controller 1 Slave ,
Controller 2 Master ,
Controller 3 Master.
The FreeNas see all disk in bios bat after boot see just Controller 2 and 3(jut 2 disk from 6 disk).
If I set the controller in bios to AHCI don't see any disk , same if I use RAID , only in IDE see just 2 disk from 6
Any help please . (I'm new to Linux)


THX

 

[marbus90]

Buy a new system according to https://forums.freenas.org/index.php?threads/hardware-recommendations-read-this-first.23069/

 

[E_B]

If I install a older version is working (8.3) . Can see all disks. Maybe is a issues in the software . My motherboard is just 1 yer old. The idea was to transform an old pc in nas.

 

[pirateghost]

If I install a older version is working (8.3) . Can see all disks. Maybe is a issues in the software . My motherboard is just 1 yer old. The idea was to transform an old pc in nas.

Then your expectations have been wrong from the beginning. Please read the hardware requirements and understand them.

 

[E_B]

freenas 8.3.2 transfer rate w-20mbs r-40mbs vs windows server 2008 r2 w&r over 114mbs. with same hardware. I loose the time with freenas.

 

[pirateghost]

Because you don't have the hardware for FreeNAS....

 

[Ericloewe]

freenas 8.3.2 transfer rate w-20mbs r-40mbs vs windows server 2008 r2 w&r over 114mbs. with same hardware. I loose the time with freenas.

Realtek.

Read the hardware sticky. *Then* you're free to complain.