I'm trying to get something/anything to boot in the VM tab on the new RC. I have added a VM, added the necessary devices, but it never gets anywhere.
I have tried both using the UEFI and the UEFI_CSM. With CSM I get nothing. Even when I dig up the console connection. When I use UEFI, I get the UEFI shell, but it never shows anything but a Block device which I assume is the empty drive I created. No CDROM mounted for me to boot from, just:
Typing exit there lets me go and select the CDROM from the byhve Boot Manager, but it just dumps me back to the same UEFI shell.
I'm currently trying to do this with RancherOS ISO, but I have tried a couple others as well. Same results. I have had success in getting RancherOS to install via iohyve commands, so I know it's possible. I'm just stuck.
Anyone else had any success with this? All my forum searching has so far come to nothing.
I have tried both using the UEFI and the UEFI_CSM. With CSM I get nothing. Even when I dig up the console connection. When I use UEFI, I get the UEFI shell, but it never shows anything but a Block device which I assume is the empty drive I created. No CDROM mounted for me to boot from, just:
Code:
UEFI Interactive Shell v2.1 EDK II UEFI v2.40 (BHYVE, 0x00010000) Mapping table BLK0: Alias(s):BLK1:;BLK2: PciRoot(0x0)/Pci(0x5,0x0)/Sata(0x0,0x0,0x0) Press ESC in 2 seconds to skip startup.nsh or any other key to continue. Shell>
Typing exit there lets me go and select the CDROM from the byhve Boot Manager, but it just dumps me back to the same UEFI shell.
I'm currently trying to do this with RancherOS ISO, but I have tried a couple others as well. Same results. I have had success in getting RancherOS to install via iohyve commands, so I know it's possible. I'm just stuck.
Anyone else had any success with this? All my forum searching has so far come to nothing.