Hello, I am new to FreeNAS and Linux. I was hoping with more experience could help me figure out if a failure is occurring on the hardware or FreeNAS side.
The box runs FreeNAS 9.1.2.2. It is a member of our ActiveDirectory network which probably has 30,000+ users. The box has about 30TB of storage on 10x 4TB Seagate NAS disks. The share is CIFS. The dual 8-core processors are Xeon's from about 2009. 16GB of RAM which I was going to increase if needed. sys volumes are on a separate 2TB drive.
The box has been working correctly for a several days across a couple of restarts. Friday evening I increased the load on the box as I began populating it as a backup of other data. The box dropped off the network within a few minutes. Unfortunately on Saturday our lab suffered a power outage so I could not get anyone there to inspect the console.
I am 1000+ miles from the actual machine so my ability to troubleshoot is limited. A co-worker took this screen shot this morning. This error now occurs every time the machine boots.
In short the error is:
Fatal trap 12: page fault while in kernel mode
cpuid = 7; apic id = 07
fault virtual address = 0x2b8
fault code = supervisor read data, page not present
instruction pointer = 0x20:0xffffffff818ab9b5
stack pointer = 0x28:0xffffff83705ed6b0
frame pointer = 0x28:0xffffff83705ed6d0
...
current process = 534 (txg_thread_enter)
Suggestions?
Thank You
The box runs FreeNAS 9.1.2.2. It is a member of our ActiveDirectory network which probably has 30,000+ users. The box has about 30TB of storage on 10x 4TB Seagate NAS disks. The share is CIFS. The dual 8-core processors are Xeon's from about 2009. 16GB of RAM which I was going to increase if needed. sys volumes are on a separate 2TB drive.
The box has been working correctly for a several days across a couple of restarts. Friday evening I increased the load on the box as I began populating it as a backup of other data. The box dropped off the network within a few minutes. Unfortunately on Saturday our lab suffered a power outage so I could not get anyone there to inspect the console.
I am 1000+ miles from the actual machine so my ability to troubleshoot is limited. A co-worker took this screen shot this morning. This error now occurs every time the machine boots.
In short the error is:
Fatal trap 12: page fault while in kernel mode
cpuid = 7; apic id = 07
fault virtual address = 0x2b8
fault code = supervisor read data, page not present
instruction pointer = 0x20:0xffffffff818ab9b5
stack pointer = 0x28:0xffffff83705ed6b0
frame pointer = 0x28:0xffffff83705ed6d0
...
current process = 534 (txg_thread_enter)
Suggestions?
Thank You