dropofdreams
Cadet
- Joined
- Jun 17, 2014
- Messages
- 3
Hey there. So I've been using the 9.3 nightlies for quite some time now. every few nights, I'll get an email telling me that there is an update available. Like a good boy, I followed through when no one was using the server and the update completed and the system rebooted. Normally, after a few minutes, I'm prompted to re-login to the web GUI. In this instance, I never was. This isn't a first in the time that I've been using freenas but I figured I'd go clear whatever prompt I had assumed was causing the hangup in the morning. Morning came and I headed down to the garage where the servers are and I turned on the console to find that freenas didn't boot at all...It actually gave me an error telling me that it had failed to complete an operation. A reboot doesn't resolve this. I figured I'd pull the flash drive to see if there were logs on it that would explain what was going on but found that I couldn't read from the flashdrive. It's being shown as a RAW partition. My questions are whether or not the data I have on my mechanical raid array is lost and or will I be able to resolve the failure to boot issue with the my current configuration intact?