Without to much hassle I got my freenas box running smooth, and wanted to test ZFS raid array.
So I unplugged the drive while streaming video on my computer. No hiccups, drive gets disconnected and still keeps going.
I then proceed to re-attach the drive (simulating putting a new disk in)
seconds after I get:
"cam_periph_alloc: attmpt to re-allocate valid device ada0 rejected
adaasync: unable to attach to new device due to status 0x6"
Doing a scrub, then "zpool status":
"Volume1: Degraded
Raidz1: Degraded
Ada0p2: Unavail Cannon open
ada1p2: Online
ada2p2: Online"
"camcontrol reset all":
"Reset of bus 0 was successful..
...
...
Reset of bus 6 returned error 0x3a"
Am I doing something wrong here? I'm set up for AHCI in bios. I was under the impression you could hot swap with ZFS under Freenas 8?
Specs are as followed:
Running 8.0.3
AMD E-350
8gb of ram
x3 160gb drives
So I unplugged the drive while streaming video on my computer. No hiccups, drive gets disconnected and still keeps going.
I then proceed to re-attach the drive (simulating putting a new disk in)
seconds after I get:
"cam_periph_alloc: attmpt to re-allocate valid device ada0 rejected
adaasync: unable to attach to new device due to status 0x6"
Doing a scrub, then "zpool status":
"Volume1: Degraded
Raidz1: Degraded
Ada0p2: Unavail Cannon open
ada1p2: Online
ada2p2: Online"
"camcontrol reset all":
"Reset of bus 0 was successful..
...
...
Reset of bus 6 returned error 0x3a"
Am I doing something wrong here? I'm set up for AHCI in bios. I was under the impression you could hot swap with ZFS under Freenas 8?
Specs are as followed:
Running 8.0.3
AMD E-350
8gb of ram
x3 160gb drives