Sorry if this has been posted before but I cannot find threads referencing this particular issue.
I am virtualizing Truenas 23.10.1.1 on Proxmox with a PCI-passthrough drive controller and PCI-passthrough Intel i7-8700 iGPU (Intel UHD graphics 630)
I believe Truenas can see the iGPU because in Advanced settings I am able to isolate the "Intel Corporation CoffeeLake-S GT2 [UHD Graphics 630]" and after a reboot it does show up as an Isolated GPU Device.
However, regardless of whether I have it set as an Isolated GPU Device or not, when I attempt to configure either Jellyfin or Plex apps, the only option I get to allocate an Intel iGPU is the following:
"Allocate 0 gpu.intel.com/i915 GPU"
Every other post I can find about Intel GPU transcoding problems says they can allocate between 1-5 instances of the iGPU then it's somehow not working... but I can't even get that far.
Any ideas?
I am virtualizing Truenas 23.10.1.1 on Proxmox with a PCI-passthrough drive controller and PCI-passthrough Intel i7-8700 iGPU (Intel UHD graphics 630)
I believe Truenas can see the iGPU because in Advanced settings I am able to isolate the "Intel Corporation CoffeeLake-S GT2 [UHD Graphics 630]" and after a reboot it does show up as an Isolated GPU Device.
However, regardless of whether I have it set as an Isolated GPU Device or not, when I attempt to configure either Jellyfin or Plex apps, the only option I get to allocate an Intel iGPU is the following:
"Allocate 0 gpu.intel.com/i915 GPU"
Every other post I can find about Intel GPU transcoding problems says they can allocate between 1-5 instances of the iGPU then it's somehow not working... but I can't even get that far.
Any ideas?