<div class="bbWrapper">Hi,<br />
<br />
I thought this was fixed, but it apparently isn't (?).<br />
<br />
I do an install of CentOS 7 (1805) as everything later seems to crash with that MokUtil bug. (Has anyone got Centos-7 1810 working in FreeNAS 11.2 bHyve? )<br />
<br />
I'm installing on FreeNAS 11.2 Stable. Everything goes great. I install using the Centos7 GUI. I put in the Server with GUI config and everything goes fine.<br />
<br />
Since the MokUtil bug is still there, I don't dare upgrading so I keep the excludes=shim*,mokutil* line in my /etc/yum.conf file.<br />
<br />
I perform a 'yum update' and it works great as long as I use the '--skip-broken' due to the kernel conflict with excluding the upgrades in the line above.<br />
<br />
Great. Everything is working like a champ. I reboot.<br />
<br />
It works fine and reboots just great.<br />
<br />
Then, I power off the machine and restart, it goes back to the installer.<br />
<br />
So, I then shut it down again. Edit the VM's devices to make sure the DVD drive is at 1005 in the boot order.<br />
<br />
It still comes up with the installer. It seems that bHyve can't find the disk/boot strap. (but it's there in the partition where I put it.)<br />
<br />
So, I go into the installer, it finds the install and mounts it under /mnt. I try re-copying the /boot/efi/EFI/centos/grubx64.efi to /boot/efi/EFI/BOOT/BOOTX64.EFI<br />
<br />
Same behavior.<br />
<br />
So, what is the magic process to get this working? <br />
<br />
Thank you!<br />
<br />
P.</div>
<div class="bbWrapper">So, it looks like everything is good. I can now use the image as my base and I've successfully cloned it and the clone boots as well.</div>
