Automatic scrubs issue

Status
Not open for further replies.

dominator99

Dabbler
Joined
Jan 2, 2014
Messages
35
Hi All

On my Freenas 2 PC I've setup automatic weekly scrubs on my 3 mirrors. Today it started as usual but a couple of minutes later I noticed there was no HDD LED activity. I checked the scrub status & it listed as 'in progress' on all 3 mirrors? When I checked console messages in the footer it reported 2 timeouts (see attachment). I ran the shell 'zpool status' command & it listed scrubs 'in progress'.
It seems that the scrubs have now completed successfully but any ideas on the 'timeout' issue shown in the attachment? Should I be concerned?
  • The system has no alerts
 

Attachments

  • black freenas 11.1 scrubs.PNG
    black freenas 11.1 scrubs.PNG
    62.9 KB · Views: 189
Last edited:

rs225

Guru
Joined
Jun 28, 2014
Messages
878
11.1 has a scrub bug that causes it to slow or stop. This is probably what happened, and then it cleared and continued. Most reports end up hard resetting the system.
 

dominator99

Dabbler
Joined
Jan 2, 2014
Messages
35
11.1 has a scrub bug that causes it to slow or stop. This is probably what happened, and then it cleared and continued. Most reports end up hard resetting the system.
So far no hard resetting of system but I'll monitor the situation to see if it re-occurs
 
Status
Not open for further replies.
Top