I'm running FreeNAS-8.2.0-RELEASE-p1-x86 (r11950) and have been using the motherboard's NIC (msk0) w/ no issue. I recently decided to install 2 PCI cards - a TrendNet TEG-PCITXR (re0) and an Atheros wireless NIC. The TrendNet NIC (re0) does appear on the list of available interfaces and has been configured w/ a static IP of .100. However, I'm unable to access this box as soon as I set the WebGUI IP to this NIC (.100). So, how do I know if this NIC is working in the first place? I tried pinging .100 over the network and it responded fine.
Does this mean I'd have to install the nge(4) drivers for the TrendNet NIC from http://www.freebsd.org/releases/8.2R/hardware.html#ETHERNET?
On the other hand, the Atheros NIC wouldn't even show up as an available interface.
Thanks in advance for your help.
[root@freenas ~]# ifconfig
msk0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=c011a<TXCSUM,VLAN_MTU,VLAN_HWTAGGING,TSO4,VLAN_HWTSO,LINKSTATE>
ether X:X:X:X:X:X
inet 192.168.1.101 netmask 0xffffff00 broadcast 192.168.1.255
media: Ethernet autoselect (100baseTX <full-duplex,flowcontrol,rxpause,t
xpause>)
status: active
re0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=389b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,WOL_UCAST
,WOL_MCAST,WOL_MAGIC>
ether X:X:X:X:X:X
inet 192.168.1.100 netmask 0xffffff00 broadcast 192.168.1.255
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
options=3<RXCSUM,TXCSUM>
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3
inet6 ::1 prefixlen 128
inet 127.0.0.1 netmask 0xff000000
nd6 options=3<PERFORMNUD,ACCEPT_RTADV>
[root@freenas ~]#
none1@pci0:0:31:3: class=0x0c0500 card=0x21961019 chip=0x27da8086 rev=0x01
hdr=0x00
vendor = 'Intel Corporation'
device = 'Intel[R] 82801G (ICH7 Family) C- 27DA (82801G)'
class = serial bus
subclass = SMBus
mskc0@pci0:3:0:0: class=0x020000 card=0x80561019 chip=0x436411ab rev=0x12
hdr=0x00
vendor = 'Marvell Semiconductor (Was: Galileo Technology Ltd)'
device = 'Yukon PCI-E Gigabit Ethernet Controller (88E8056)'
class = network
subclass = ethernet
re0@pci0:4:1:0: class=0x020000 card=0x816910ec chip=0x816910ec rev=0x10 hdr=0x00
vendor = 'Realtek Semiconductor'
device = 'Single Gigabit LOM Ethernet Controller (RTL8110)'
class = network
subclass = ethernet
none2@pci0:4:2:0: class=0x020000 card=0x30001799 chip=0x001b168c rev=0x01
hdr=0x00
vendor = 'Atheros Communications Inc.'
device = 'AR5006 family 802.11abg Wireless NIC'
class = network
subclass = ethernet
[root@freenas ~]#
Does this mean I'd have to install the nge(4) drivers for the TrendNet NIC from http://www.freebsd.org/releases/8.2R/hardware.html#ETHERNET?
On the other hand, the Atheros NIC wouldn't even show up as an available interface.
Thanks in advance for your help.
[root@freenas ~]# ifconfig
msk0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=c011a<TXCSUM,VLAN_MTU,VLAN_HWTAGGING,TSO4,VLAN_HWTSO,LINKSTATE>
ether X:X:X:X:X:X
inet 192.168.1.101 netmask 0xffffff00 broadcast 192.168.1.255
media: Ethernet autoselect (100baseTX <full-duplex,flowcontrol,rxpause,t
xpause>)
status: active
re0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=389b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,WOL_UCAST
,WOL_MCAST,WOL_MAGIC>
ether X:X:X:X:X:X
inet 192.168.1.100 netmask 0xffffff00 broadcast 192.168.1.255
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
options=3<RXCSUM,TXCSUM>
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3
inet6 ::1 prefixlen 128
inet 127.0.0.1 netmask 0xff000000
nd6 options=3<PERFORMNUD,ACCEPT_RTADV>
[root@freenas ~]#
none1@pci0:0:31:3: class=0x0c0500 card=0x21961019 chip=0x27da8086 rev=0x01
hdr=0x00
vendor = 'Intel Corporation'
device = 'Intel[R] 82801G (ICH7 Family) C- 27DA (82801G)'
class = serial bus
subclass = SMBus
mskc0@pci0:3:0:0: class=0x020000 card=0x80561019 chip=0x436411ab rev=0x12
hdr=0x00
vendor = 'Marvell Semiconductor (Was: Galileo Technology Ltd)'
device = 'Yukon PCI-E Gigabit Ethernet Controller (88E8056)'
class = network
subclass = ethernet
re0@pci0:4:1:0: class=0x020000 card=0x816910ec chip=0x816910ec rev=0x10 hdr=0x00
vendor = 'Realtek Semiconductor'
device = 'Single Gigabit LOM Ethernet Controller (RTL8110)'
class = network
subclass = ethernet
none2@pci0:4:2:0: class=0x020000 card=0x30001799 chip=0x001b168c rev=0x01
hdr=0x00
vendor = 'Atheros Communications Inc.'
device = 'AR5006 family 802.11abg Wireless NIC'
class = network
subclass = ethernet
[root@freenas ~]#