Nick Howard
Contributor
- Joined
- May 20, 2014
- Messages
- 129
Ok so I've read numerous posts on this and also read the manual which states the only way to set this up is via the CLI using iscontrol. I find it a little strange this isn't built in and enabled from within the GUI. Is this something that will be added in the future?
I'm willing to give it go however, although I'm only just getting to grips with the CLI and from what I've read this will still lose all the settings after any reboot of the freenas, again not an ideal.
The reason I'm wanting to try this is because I've just got my hands on a FC san with 45 x 750gb drives. I've got a fc/iscsi router and have it all set up from that end. I've set my pc up as an initiator and can see all the storage fine, it would just be ideal if I could get freenas to use it.
I'm willing to give it go however, although I'm only just getting to grips with the CLI and from what I've read this will still lose all the settings after any reboot of the freenas, again not an ideal.
The reason I'm wanting to try this is because I've just got my hands on a FC san with 45 x 750gb drives. I've got a fc/iscsi router and have it all set up from that end. I've set my pc up as an initiator and can see all the storage fine, it would just be ideal if I could get freenas to use it.
Last edited: