aufalien
Patron
- Joined
- Jul 25, 2013
- Messages
- 374
I've a 9.1.1 box (PUSH) that I would like to replicate to a fresh 9.2.1.5 box (PULL).
My volume is foo and the dataset of BAR.
Both boxes have foo/BAR defined.
On PUSH, I have a snap shot of foo/BAR, no snapshots on PULL.
Under replication tasks;
Filesystem/Volume = foo/BAR
Remote ZFS filesystems name = foo/BAR
Initialize remote side for once is enabled
Remote host has an IP address which is valid and reachable.
I have chosen to not use a dedicated user.
I dropped into the command and followed troubleshooting on page 108-109 of the manual.
The ssh test works fine, no password is asked so my preshared key works;
ssh -vv -i /data/ssh/replication 10.0.10.99
Also doing the next test;
zfs send foo/BAR@auto-20140423.2245-2h | ssh -i /data/ssh/replication 10.0.10.99 zfs receive foo/BAR@auto-20140423.2245-2h
Yields this error;
Could not create directory '/root/.ssh'.
cannot receive new filesystem stream: destination 'foo/BAR' exists
must specify -F to overwrite it
warning: cannot send 'foo/BAR@auto-20140423.2245-2h': Broken pipe
I assume this is fine as the option "initialize remote side for once" is doing the -F.
However using the GUI, I cannot get this process to launch.
What am I doing wrong?
My volume is foo and the dataset of BAR.
Both boxes have foo/BAR defined.
On PUSH, I have a snap shot of foo/BAR, no snapshots on PULL.
Under replication tasks;
Filesystem/Volume = foo/BAR
Remote ZFS filesystems name = foo/BAR
Initialize remote side for once is enabled
Remote host has an IP address which is valid and reachable.
I have chosen to not use a dedicated user.
I dropped into the command and followed troubleshooting on page 108-109 of the manual.
The ssh test works fine, no password is asked so my preshared key works;
ssh -vv -i /data/ssh/replication 10.0.10.99
Also doing the next test;
zfs send foo/BAR@auto-20140423.2245-2h | ssh -i /data/ssh/replication 10.0.10.99 zfs receive foo/BAR@auto-20140423.2245-2h
Yields this error;
Could not create directory '/root/.ssh'.
cannot receive new filesystem stream: destination 'foo/BAR' exists
must specify -F to overwrite it
warning: cannot send 'foo/BAR@auto-20140423.2245-2h': Broken pipe
I assume this is fine as the option "initialize remote side for once" is doing the -F.
However using the GUI, I cannot get this process to launch.
What am I doing wrong?