Hi Folks,
Looking for guidance here, running TrueNAS-12.0-U5 on a custom built box. I recently have replaced two failing internal SAS drives following the procedure to replace a drive from the doc (offline, replace, etc). Resilvering has completed and the old drives are out of the system. SMART tests are scheduled and running daily, however, in the GUI I still see old serial numbers attached to now new drives (same device names). How do I force the system to update them? SMART runs do not seem to do it. CLI does show new numbers, but not GUI.
Thanks.
Looking for guidance here, running TrueNAS-12.0-U5 on a custom built box. I recently have replaced two failing internal SAS drives following the procedure to replace a drive from the doc (offline, replace, etc). Resilvering has completed and the old drives are out of the system. SMART tests are scheduled and running daily, however, in the GUI I still see old serial numbers attached to now new drives (same device names). How do I force the system to update them? SMART runs do not seem to do it. CLI does show new numbers, but not GUI.
Thanks.