I am trying to start up a brand new VM and I can't get VNC viewer to connect. I am certain I am connecting to the correct IP address and ports.
If I deselect the "wait to boot" option in the VNC device, then my VM immediately stops. I have tried in both the 11 RC and latest nightly. I have tried adding a CD-ISO and disk device and numerous configurations, but still can't seem to connect. Is it possible to setup a new VM from the GUI and an ISO or do I need to work from the CLI?
If I deselect the "wait to boot" option in the VNC device, then my VM immediately stops. I have tried in both the 11 RC and latest nightly. I have tried adding a CD-ISO and disk device and numerous configurations, but still can't seem to connect. Is it possible to setup a new VM from the GUI and an ISO or do I need to work from the CLI?