TN Core - Samba share - prefererred / primary ethernet port to use - howto? Shares > SMB > edit > bind IP adresses doesn't work for me

[flashdrive]

Hello,

Is there a way to tell Samba to use a NIC / Mac Address / etc. as a primary NIC?

I have 2 NIC ports active:

1. which is WiFi via adapter
2. 10 GBit LAN

How do I set up that Samba will use 2. - 10 GBit LAN ?


the reason for the wifi connection is mentioned here:

start TN host other than Wake on LAN - no more LAN cable available (no ILO)

Hello, I want to start the host remote. The problem is that I do have only 1 available LAN cable to connect. This goes to the HPE NIC, which will not work with WoL (although it is supposed to do so) The lights of the HPE NIC ports go out once the host is shut down. This is not true for the...

www.truenas.com

 

[flashdrive]

possible solution:

start TN host other than Wake on LAN - no more LAN cable available (no ILO)

Hello, I want to start the host remote. The problem is that I do have only 1 available LAN cable to connect. This goes to the HPE NIC, which will not work with WoL (although it is supposed to do so) The lights of the HPE NIC ports go out once the host is shut down. This is not true for the...

www.truenas.com

 

[flashdrive]

using

Shares > SMB > edit > bind IP adresses to 10 GBit NICs bridge

doesn't do the trick for me:

- restarted samba service

- restarted TN Core host

always only about 3 MByte/s are being transferred to a Win 10 client. This seems to be the WiFi connection.

The TN Core host is set up with the 2x 10 GBit NIC ports in bridge mode.

I have set these parameters additionally to no avail:

bind interfaces only = yes
interfaces = lo bxe0 bxe1 bridge1

What else is there to try?