"Error Occurred" during jail install
PLEASE DO NOT READ THIS THREAD. MUCH OF THE INFORMATION WAS CHANGED WHICH NECESSITATED A NEW THREAD TITLE
So, I was stuck forever on the setup to install the jail pbi. The Jail IP Address field was just "------", so i couldn't get to the step to actually upload the pbi file. I finally figured out to set up an Interface like so:
Name: LAN
DHCP: checked
all other fields left as unchanged/default
Alias
iPv4 Address: 192.168.1.105 My Freenas ip is 192.168.1.104
ipv4 Netmask: /24 255.255.255.0
all other fields left as unchanged/default
I assume the above settings are correct?
Here's my problem: Steps 1 and 2 go by quickly. During Step 3 of the jail pbi install my system seems to freeze. The progress bar goes to 100% and the progress bar changes to that moving one from left to right(no % indicator). I watched youtube videos that show people uploading the jail pbi and step 3 takes a couple of seconds, but I let it go for about 10 minutes. The hard drive in the NAS was making very loud clicking noises so it was kind of scaring me a bit. After about 10 minutes it "finished" and I got an "error occurred" message at the top of my GUI. I had to reboot the NAS. No plugin jail. I'm using 8.2 beta 3 with UFS drives. Using chrome to access the GUI.
Is this normal? Any other comments? Is there a way to install the jail via command line?
Thanks for any help!
edited: for more detail
Regards,
Craig
PLEASE DO NOT READ THIS THREAD. MUCH OF THE INFORMATION WAS CHANGED WHICH NECESSITATED A NEW THREAD TITLE
So, I was stuck forever on the setup to install the jail pbi. The Jail IP Address field was just "------", so i couldn't get to the step to actually upload the pbi file. I finally figured out to set up an Interface like so:
Name: LAN
DHCP: checked
all other fields left as unchanged/default
Alias
iPv4 Address: 192.168.1.105 My Freenas ip is 192.168.1.104
ipv4 Netmask: /24 255.255.255.0
all other fields left as unchanged/default
I assume the above settings are correct?
Here's my problem: Steps 1 and 2 go by quickly. During Step 3 of the jail pbi install my system seems to freeze. The progress bar goes to 100% and the progress bar changes to that moving one from left to right(no % indicator). I watched youtube videos that show people uploading the jail pbi and step 3 takes a couple of seconds, but I let it go for about 10 minutes. The hard drive in the NAS was making very loud clicking noises so it was kind of scaring me a bit. After about 10 minutes it "finished" and I got an "error occurred" message at the top of my GUI. I had to reboot the NAS. No plugin jail. I'm using 8.2 beta 3 with UFS drives. Using chrome to access the GUI.
Is this normal? Any other comments? Is there a way to install the jail via command line?
Thanks for any help!
edited: for more detail
Regards,
Craig