Hello, I am trying to set up LACP on my freenas. I have a Nortel 5520 switch that has LACP enabled for ports 29/30.
here is the line from show lacp port command
29 32768 Active A Long 10 8202 0 Active
30 32768 Active A Long 10 8202 0 Active
when I boot freeNAS up I get that I can access my box on 2 ip address of .134 and .107. From here I try and set up lagg0, the GUI fails to set up LACP and doesn't bring me back to where I set an ip address for the lagg. I tried to do this from the console as well, I assigned an ip address to lagg0 of .5 with no luck. I am unable to reach my freeNAS from any ip. Before setting up the lagg, I verified that no interfaces were configured under view interfaces before I started. If someone could point me in the right direction I would be grateful.
here is the line from show lacp port command
29 32768 Active A Long 10 8202 0 Active
30 32768 Active A Long 10 8202 0 Active
when I boot freeNAS up I get that I can access my box on 2 ip address of .134 and .107. From here I try and set up lagg0, the GUI fails to set up LACP and doesn't bring me back to where I set an ip address for the lagg. I tried to do this from the console as well, I assigned an ip address to lagg0 of .5 with no luck. I am unable to reach my freeNAS from any ip. Before setting up the lagg, I verified that no interfaces were configured under view interfaces before I started. If someone could point me in the right direction I would be grateful.