SOLVED RMA'd board making the UI freeze randomly

[shnurov]

So I had either fried or corrupted my last board or completely corrupted the installation/HDD by forcing a hard reboot because I got impatient :(

Now I got the new board in and I'm having a few weird issues after running a fresh install on the new USB sticks (used previously, but formatted).

• I imported 2 datasets I previously had, 1x8tb backup and 3x1tb media. The media went well, but the 8tb was 'stuck' at importing, the screen just never went away until I pressed the X.
• Whenever I would do anything to the 8TB drive (which is quite new and hasn't been used much) I get some UI freezes like infinite 'loading' sections at different screens: Reporting/Partition, System/General, System/Advanced and whenever I would look into the 'volumes' options.
• The green status console (?) on the bottom is shifted to the right and is now blank.

• The ALERT is now red with some messages:

1. CRITICAL: The volume set_3x1tb (ZFS) state is UNAVAIL: One or more devices are faulted in response to IO failures.
2. CRITICAL: The volume remote (ZFS) state is UNAVAIL: One or more devices are faulted in response to IO failures.
3. WARNING: New feature flags are available for volume set_3x1tb. Refer to the "Upgrading a ZFS Pool" section of the User Guide for instructions.
4. WARNING: New feature flags are available for volume remote. Refer to the "Upgrading a ZFS Pool" section of the User Guide for instructions.

• Whenever I refer to the 'upgrade' ZFS pool I either get a 'failed: locked db' or 'The pool failed to upgraded: This system supports ZFS pool feature flag'

Now if I press 'reboot' or 'shutdown' or anything else it goes to the appropriate screen (server is rebooting) and then 30s later (Chrome feature?) it auto-refreshed back into the login page.

So far I've completely erased the 8tb drive on my workstation and plugged it back in with no change in operation, freezes the GUI at 'Creating volume'

Now there is not critical data on any of the datasets, so I'm not worried if I have to start from scratch on a few things.

System in question is my 'home/replication' in the signature.

 

[Sakuru]

Do you have any of your drives connected to the Marvell ports?

 

[shnurov]

I think so - I did solve my issue by clearing out the HDD's and resetting the pools.
I think I may have imported the pools wrongly.

 

[Sakuru]

Marvell SATA controllers have compatibility issues with FreeNAS. It is recommended to only use the Intel ports on that motherboard.