revengineer
Contributor
- Joined
- Oct 27, 2019
- Messages
- 193
I have a WD red drive with one current pending sector, see smart data below. The drive has been stable in this state and I would like to use it for non-critical backup. So I am not concerned about loosing files. Is there a way to force relocation of that sector so that it is no longer used?
Code:
Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x002f 200 200 051 Pre-fail Always - 103 3 Spin_Up_Time 0x0027 184 183 021 Pre-fail Always - 5800 4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 583 5 Reallocated_Sector_Ct 0x0033 200 200 140 Pre-fail Always - 0 7 Seek_Error_Rate 0x002e 100 253 000 Old_age Always - 0 9 Power_On_Hours 0x0032 065 065 000 Old_age Always - 26229 10 Spin_Retry_Count 0x0032 100 100 000 Old_age Always - 0 11 Calibration_Retry_Count 0x0032 100 253 000 Old_age Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 36 192 Power-Off_Retract_Count 0x0032 200 200 000 Old_age Always - 17 193 Load_Cycle_Count 0x0032 200 200 000 Old_age Always - 634 194 Temperature_Celsius 0x0022 114 104 000 Old_age Always - 36 196 Reallocated_Event_Count 0x0032 200 200 000 Old_age Always - 0 197 Current_Pending_Sector 0x0032 200 200 000 Old_age Always - 1 198 Offline_Uncorrectable 0x0030 100 253 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 1 200 Multi_Zone_Error_Rate 0x0008 200 200 000 Old_age Offline - 0