SOLVED problem with gigabit network card

[sandoz]

i managed to upgrade to 9.1.1, everything seems to be ok.
Only problem i have is with my ethernet card, a belkin gigabit network card:
Sep 14 22:30:15 freenas kernel: skc0: <Belkin F5D5005 Gigabit Ethernet> port 0x2000-0x20ff mem 0x8a100000-0x8a103fff irq 17 at device 6.0 on pci0
Sep 14 22:30:15 freenas kernel: skc0: Belkin Gigabit Desktop Card rev. (0x1)
Sep 14 22:30:15 freenas kernel: sk0: <Marvell Semiconductor, Inc. Yukon> on skc0

hardware seems to be recognized ok, but i keep getting this as soon as i try to ssh or go to the GUI
Sep 14 22:35:21 freenas kernel: sk0: phy failed to come ready
Sep 14 22:35:21 freenas last message repeated 5 times
Sep 14 22:35:21 freenas kernel: sk0: link state changed to DOWN
Sep 14 22:35:21 freenas kernel: sk0: phy failed to come ready
Sep 14 22:35:22 freenas last message repeated 9 times
Sep 14 22:35:23 freenas kernel: sk0: link state changed to UP
Sep 14 22:35:24 freenas kernel: sk0: phy failed to come ready
Sep 14 22:36:10 freenas kernel: sk0: link state changed to DOWN
Sep 14 22:36:13 freenas kernel: sk0: link state changed to UP

card worked fine in 8.3.0
anyone have an idea?

 

[cyberjock]

My first guess is that your network card driver might not be completely updated to work with FreeBSD 9. My only 2 recommendations are to wait until its fixed(assuming FreeBSD has a ticket on the issue) or get a different card(Intel NICs work great!)

 

[sandoz]

perhaps i was a little bit too fast. Right now its working as it should be afetr some reboots