So I tried to upgrade to 9.3 from 9.2 via web GUI, and of course my box doesn't boot afterwards. I backed up my config but I'm having a lot of trouble getting it reinstalled on my flash drive.
The installer runs, and says it completes, but when the machine reboots it only shows a flashing cursor, and nothing else. All boot devices are disabled other than USB boot. The flash drive I'm using was the same 8GB one it worked with perfectly for 10 months. I also bought a new 16GB drive and I get the same results. I did try installing to a 2GB flash drive as a test, and it will boot all the way from that. I'm not sure why, especially since Freenas recommends at least an 8GB flash drive. Any ideas? Thanks
The installer runs, and says it completes, but when the machine reboots it only shows a flashing cursor, and nothing else. All boot devices are disabled other than USB boot. The flash drive I'm using was the same 8GB one it worked with perfectly for 10 months. I also bought a new 16GB drive and I get the same results. I did try installing to a 2GB flash drive as a test, and it will boot all the way from that. I'm not sure why, especially since Freenas recommends at least an 8GB flash drive. Any ideas? Thanks