I've created 3 jails within FreeNAS with VNET. I'm definitely no expert on creating these jails but the virtual networking card is paired with an epair and then bridged with the physical network adapter.
Within each jail I've setup a static IP address however I'd like to reserve this IP address on pfSense which requires a MAC address.
Looking at ifconfig however I have a MAC address for the epair interface and a MAC address for the vnet interface.
Within the jail
Which is the MAC address I need to add to pfSense -- the ether or hwaddr?
Within each jail I've setup a static IP address however I'd like to reserve this IP address on pfSense which requires a MAC address.
Looking at ifconfig however I have a MAC address for the epair interface and a MAC address for the vnet interface.
Within the jail
Code:
#> ifconfig epair0b: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500 options=8<VLAN_MTU> ether 02:ff:60:ba:b5:82 hwaddr 02:a8:d0:00:0b:0b inet 10.0.1.158 netmask 0xffffff00 broadcast 10.0.1.255 nd6 options=1<PERFORMNUD> media: Ethernet 10Gbase-T (10Gbase-T <full-duplex>) status: active groups: epair
Which is the MAC address I need to add to pfSense -- the ether or hwaddr?