petr
Contributor
- Joined
- Jun 13, 2013
- Messages
- 142
After upgrading to 9.3, I am seeing following warning:
WARNING: Firmware version 15 does not match driver version 16 for /dev/mps0
Research led me to conclusion that I need to upgrade firmware on my M1015. However, when I look at the LSI site, they list P19 and P20 - which is above the version 16 in the warning.
My question is twofold - is it in any way unsafe to run with this warning? Secondly, if I do decide to upgrade, can I flash higher version of the firmware?
Here is an output from sas2flash:
I've used sas2flash from DOS boot disk before, is there a way to use it from FreeNAS? I am assuming that it's not something safe to do while the system is running..
WARNING: Firmware version 15 does not match driver version 16 for /dev/mps0
Research led me to conclusion that I need to upgrade firmware on my M1015. However, when I look at the LSI site, they list P19 and P20 - which is above the version 16 in the warning.
My question is twofold - is it in any way unsafe to run with this warning? Secondly, if I do decide to upgrade, can I flash higher version of the firmware?
Here is an output from sas2flash:
Code:
[root@freenas] ~# sas2flash -listall LSI Corporation SAS2 Flash Utility Version 14.00.00.00 (2012.07.04) Copyright (c) 2008-2012 LSI Corporation. All rights reserved Adapter Selected is a LSI SAS: SAS2008(B2) Num Ctlr FW Ver NVDATA x86-BIOS PCI Addr ---------------------------------------------------------------------------- 0 SAS2008(B2) 15.00.00.00 0f.00.00.05 No Image 00:01:00:00 Finished Processing Commands Successfully. Exiting SAS2Flash.
I've used sas2flash from DOS boot disk before, is there a way to use it from FreeNAS? I am assuming that it's not something safe to do while the system is running..
Last edited: