ndboost
Explorer
- Joined
- Mar 17, 2013
- Messages
- 78
I have a pool of 5x WD Red's on an M1015 card (they actually might be split between two M1015s in my case (im not sure)..
I keep getting writer errors in zpool status, and had sector errors in the GUI.
I replaced the disk, its in the process of resilvering and been going for about 24 hours and I still see write errors in zpool status. I don't know if those are from the prior disk or if they're new. I just did a zpool clear VAULT so we'll see what happens in the next few days if i get more write errors.
the GUI errors are probably residual, but I need to be able to troubleshoot further if it comes down to it.
However when i run crystaldiskinfo on the old disk, it says its still in "good" condition, which is odd to me.
What are some other potential causes to these errors, could it be a failing sas card or failing sas backplane?
I keep getting writer errors in zpool status, and had sector errors in the GUI.
I replaced the disk, its in the process of resilvering and been going for about 24 hours and I still see write errors in zpool status. I don't know if those are from the prior disk or if they're new. I just did a zpool clear VAULT so we'll see what happens in the next few days if i get more write errors.
the GUI errors are probably residual, but I need to be able to troubleshoot further if it comes down to it.
However when i run crystaldiskinfo on the old disk, it says its still in "good" condition, which is odd to me.
What are some other potential causes to these errors, could it be a failing sas card or failing sas backplane?
Attachments
Last edited:
