KremlinJanitor
Cadet
- Joined
- Nov 1, 2022
- Messages
- 1
Hello! Fairly new user to TrueNAS here.
Earlier today i was in the process of transferring some video footage onto my samba share when my NAS crashed and then proceeded to boot loop. After browsing the forums for a possible solution to my problem I'm somewhat certain that the issue might be with the data on the pool itself. However after booting into single user mode i can't seem to mount the pool in any way, either due to it crashing with a normal import or a failure to import in read only mode because it says the drive was last in use by another system. Any possible help with the problem would be greatly appreciated!
NAS Specs (apologies for the old hardware, better than it being in a landfill):
FreeBSD 12.2-RELEASE-p14
ASUS M5A97 R2.0
AMD FX 4350
16 GB DDR3 1333MHZ
120 GB SSD (Boot Drive)
Two 4TB WD40EZAZ Drives in Raid 1
Earlier today i was in the process of transferring some video footage onto my samba share when my NAS crashed and then proceeded to boot loop. After browsing the forums for a possible solution to my problem I'm somewhat certain that the issue might be with the data on the pool itself. However after booting into single user mode i can't seem to mount the pool in any way, either due to it crashing with a normal import or a failure to import in read only mode because it says the drive was last in use by another system. Any possible help with the problem would be greatly appreciated!
NAS Specs (apologies for the old hardware, better than it being in a landfill):
FreeBSD 12.2-RELEASE-p14
ASUS M5A97 R2.0
AMD FX 4350
16 GB DDR3 1333MHZ
120 GB SSD (Boot Drive)
Two 4TB WD40EZAZ Drives in Raid 1
