Hi,
Initially I was using freenas 9. Then upgraded to Corral(10.0.2) and not able to use the VM anymore with my actual hardware so I shut the server off and stop using it.
Then last week, I wanted to turn my server back on. It boot right away but I noticed that freenas 11 was available. So I try to upgrade over the GUI thinking it was possible. Then during the upgrade I'm not sure what happened but I had issues with my motherboard and leacky caps.
Finally I replace the motherboard and CPU, reconnect everything.
With the new motherboard, all my disks are detected in the bios and I can select to boot in freenas corral in the grub but after that I get an error ATA_Identify.... CAM Status: command timeout (see attached screen shot).
I tried to unplug all the drives, only plug one, and plug all 4 drives but nothing works. always the same error.
What should I do?
Initially I was using freenas 9. Then upgraded to Corral(10.0.2) and not able to use the VM anymore with my actual hardware so I shut the server off and stop using it.
Then last week, I wanted to turn my server back on. It boot right away but I noticed that freenas 11 was available. So I try to upgrade over the GUI thinking it was possible. Then during the upgrade I'm not sure what happened but I had issues with my motherboard and leacky caps.
Finally I replace the motherboard and CPU, reconnect everything.
With the new motherboard, all my disks are detected in the bios and I can select to boot in freenas corral in the grub but after that I get an error ATA_Identify.... CAM Status: command timeout (see attached screen shot).
I tried to unplug all the drives, only plug one, and plug all 4 drives but nothing works. always the same error.
What should I do?
