Please help! I'm having trouble getting my UPS service to run correctly, running under FreeNAS 11.3-U4.1 with a CyberPower (CST135XLU) UPS connected via USB. Basically, after configuring the UPS service in the GUI (using MASTER mode and the correct port: /dev/ugen0.4), saving configuration and...

I believe I read somewhere that it is poor form to have certain services active simultaneously. It might have had to do with permissions, but the question isn't limited to that: Which services should not be simultaneously active, because they might conflict with each other? I think I plan...

On the Services/S.M.A.R.T., there is an option to log the temperature of S.M.A.R.T. supported drive higher than a given value in the "Information" field. http://doc.freenas.org/11/services.html#smart-config-opts-tab The help said: I wonder into where to find the system log it goes.

I have an APC UPS with an AP9630 network card (not using USB). I'm having issues configuring it, because the official docs are pretty minimal and ambiguous, and unfortunately so is guidance in the forum. There is an entry in the drivers list for AP9630, but the rest is unclear. Rather than...

Hello, I am attempting to stand up a FreeNAS VM on version 11.0-U4 (54848d13b). I need to get the machine to meet PCI requirements but, it is showing a lot of security errors with the system. Has anyone else run into this issue or have any advice on how to proceed. Some of the services are...

Hello all would anyone happen to know what driver is compatible with the APC Back-UPS Network 40 (BACK-UPS BN4001)? I looked through the list of drivers and couldn't find the exact driver and the APC website has little information and not driver info.

Okay, I've seen a lot of bad posts, so I'm going to do my best to create a great one! Server hardware: Motherboard: eVGA nForce 750i SLI (https://www.evga.com/support/manuals/files/122-YW-E173.pdf) CPU: Intel Core 2 Quad Q6600...

Hello, I have just installed the new FreeNAS 11.0. When I click on the Services Icon in the GUI, there is just the message "Loading ...", and no service list will be displayed. Therefore I am unable to start/stop services. Everything else seems to work fine. HP Proliant ML30 G9 vmware 6.5 (VM...

I've been trying to get my FreeNAS server to communicate with a SOLA ups S1K520. Since this model only uses a serial connection I started out by connecting both the Server and the UPS with a serial cable (15ft DB9 M/F Extension Cable). When I found out that FreeNAS was having problems trying...