Hello, I have a problem, I can't flash my H310 card in it mode. I followed this tutorial : https://www.truenas.com/community/threads/walkthrough-crossflash-dell-perc-h310.77304/ MEGAREC.EXE -adpList OK megarec.exe -cleanflash 0 OK megarec.exe -writesbr 0 sbrempty.bin OK sas2flsh.exe -c 0 -o...

A while ago I bought a Dell H310 controller in order to circumvent the SATA limitations of my server's motherboard. Yesterday I got around to installing it properly by masking two of the PCI-E pins, something that had to be done for the machine to boot at all. I followed this guide...

This post is to prevent more people from getting insane over trying to re-flash their HBAs (Host-Bus-Adapter)/SAS Controller in order to make them FreeNAS compatible. I spend an entire night finding the solution... There are countless instructions on the web on how to re-flash your IBM M1015...

I purchased a Dell PERC H310 off eBay with the idea of expanding the drives in my HP Microserver Gen8 after doing a fair amount of digging on here and finding that the general consensus was these are pretty cost effective and work great in IT mode. I then headed over to mattr's tutorial here...

I hope my personal experience on this is helpful for others! I utilized OCR software to capture some of the command outputs in text format. That's something which generally seem to be missing from forum posts on this topic. A Dell PERC H310 was flashed, using a Dell PowerEdge R720xd. Software...

Up until now it wasn't possible to use the Dell Perc H310 Mini Mono cards with FreeNAS because it just seemed not to be possible to flash them to IT mode or if you did that, your Dell server wouldn't boot up because it didn't found the proper Mini Mono card. Now someone seems to have found a...

Hello I have attempted to flash a used Dell H310 i picked up on ebay. But before I even got started it all grinded to a halt. I found this guide; https://tylermade.net/2017/06/27/how-to-crossflash-perc-h310-to-it-mode-lsi-9211-8i-firmware-hba-for-freenas-unraid/ But none of the commands worked...

Six new drives were attached to a Dell H310 which has been flashed to IT firmware (only, no boot BIOS). One of the drives was never detected. Replacing power and signal cables did nothing. Swapped power and signal cables with a working drive, and that drive continued to work while the...