cam

  1. B

    FreeNAS issues

    All, Freenas installation is seeing a bunch of CAM status ATA errors. They just seem to repeat over and over again. Is there a way to get to the shell while these errors are being displayed? After some time, I can connect to the web GUI however it states that it can't connect to the NAS. Do I...
  2. dedblank

    Cam error from backup config

    I had a hardware change and all was well. I started getting a cam error. After searching the forums, I have replaced the SATA cables, tested without the drives. Still have the cam error. Used a different flash drive. Same cam error. Bought a new flash drive, fresh install. Bam! no issues...
  3. IceBoosteR

    HELP needed -> SCSI sense: NOT READY -> pool lost

    Hi all, first of all my system config: Xeon E3-1225v3 on Dell T20 motherboard 24GB of DD3 ECC memory 10x4TB WD RED in RAIDZ2 connected 8drives via flashed M1015 and 2 drives via onbaord SATA. Seasonic Focus Plus Platinum 650W with APC Back UPS Pro 900VA in front of the system. Today I am...
  4. fabiob

    SOLVED A long journey to solve "CAM status: Command timeout" issues

    Hello community, this is my first post here, so please forgive any misses (also forr my bed English! :D) It's my third FreeNAS build, I'm a happy user of two 9.10.2U6 servers and a (less happy) user of this 11.0U4 I'm describing below: MB: Gigabyte GA-X150M-PRO-ECC CPU: Intel(R) Xeon(R) CPU...
    • fabiob
    • Thread
    • 11.0u4 cam seagate 8 tb timeout
    • Replies: 15
    • Forum: Storage
Top