Using 11.3 after upgrading from 9.10 -> 11 -> 11.1 -> 11.2 -> 11.3.
So I had to "trick" the UI after going into advanced to get it going on my static IP. I am finally upgrading from 9.10 as PLEX had my old plugin version flagged as not supported(and rightfully so, shame, but yeah time etc.). So I am rebuilding all jails, but want to keep the port forwards to the same ip's I had all along. Setting the static IP was mandatory for me rebuilding my nas functionality.
It wasn't pretty but it works fine at first glance:
Basic configuration does not work, VNET failure or missing configuration. Tried all combinations, no gucci.
After clicking install on the plugin and going into advanced, I disabled autoconfigure IPv4 but the UI
bugs out and does not allow me to set IPv4 interface and netmask (grayed out):
After toggling on and off the NAT checkbox you are able to set the desired ip and netmask, however leave the interface blank:
(Don't forget to set the name like I did in the screenshot above.)
This COULD result in a weird output, but my static IP works and the admin portal will show up using the set ip.
I may or may stumble into issues later on, but it seems like this is more of a GUI thing than anything else and I do not expect further issues.
I will update if not working correctly.
B