iandroo888
Dabbler
- Joined
- Feb 18, 2012
- Messages
- 13
So i had my FreeNAS running for a long while now (few years) with three 3tb's raid0 and two 1.5tb's raid1. For some reason, after i came back from my trip (3 days), when i turn it on, its like the mobo wont start up? like the video card is runnin at max and wont go down (does that make sense...? lol). its an older mobo so no diag code either =/
Specs is as follows
AMD 4350e
Asus Crosshair
4GB (4x1gb) corsair dominator
corsair cx430 psu
3 Seagate 3TB hd's
2 Seagate 1.5TB hd's
3 120mm fans
Corsair H50 AIO cooling
i can hear the pump come up and the water moving so its not like it wasnt being cooled and pump died or something... any ideas?
i have a hp z820 sitting around. maybe use this chance to upgrade? but i have a bunch of stuff on those drives. how would i go about on this "upgrade" ? i can keep the drives in the same order. i dont remember the names or config. i believe they are all software config thru freenas though.
can i just boot a new version of FreeNas onto a new usb, hook it up to the z820, plug in the drive and it loads it up?
Specs is as follows
AMD 4350e
Asus Crosshair
4GB (4x1gb) corsair dominator
corsair cx430 psu
3 Seagate 3TB hd's
2 Seagate 1.5TB hd's
3 120mm fans
Corsair H50 AIO cooling
i can hear the pump come up and the water moving so its not like it wasnt being cooled and pump died or something... any ideas?
i have a hp z820 sitting around. maybe use this chance to upgrade? but i have a bunch of stuff on those drives. how would i go about on this "upgrade" ? i can keep the drives in the same order. i dont remember the names or config. i believe they are all software config thru freenas though.
can i just boot a new version of FreeNas onto a new usb, hook it up to the z820, plug in the drive and it loads it up?