some error occurred with Transmission plugin

[Dan Walker]

Hi all,

My setup is this: running from an 8gb usb drive, with an internal 100gb drive for jails and configuration, also 2tb usb drive for data. 4GB ram.

I have used Freenas with Transmission and plex for about 2 weeks now. I had to move my computer and after that, my transmission install stopped working and gave the above error. If I stop the jail and start it again, I get the attached error. I have tried a complete fresh install and the same error happens. It is not an IP issue, I have it configured so the jail range is outside of my dhcp range on my router.

I cannot see this error anywhere else.

Any ideas??

 

[Dan Walker]

Bump!!

 

[cyberjock]

Are you using ZFS?

 

[Dan Walker]

Yeah, sorry should have mentioned that

Sent from my C6603 using Tapatalk

 

[cyberjock]

Yeah.. you should have 8GB of RAM minimum... it's quite possible your problems are related to out-of-memory problems.

 

[Dan Walker]

Oh. It worked for a couple of weeks just fine until I moved it. I thought it was move related! That is the maximum the machine will take so I guess I am a bit stuck. Thanks for the reply.

Sent from my C6603 using Tapatalk

 

[cyberjock]

Just be warned that the 8GB of RAM is to prevent pool corruption. There's a chance you will lose your pool due to an out-of-memory condition because you don't have the minimum RAM. That's why I put the 8GB of RAM minimum in the manual to start with.

 

[Dan Walker]

Ah. Got it. Thanks very much

Sent from my C6603 using Tapatalk

 

[tallica]

Latest Transmission plugin 2.82 is broken, please take a look: https://bugs.freenas.org/issues/5038#note-8

 

[Dan Walker]

That makes more sense, tallica. I will take both of your comments on board.