new drives size not recognized

[tod]

Hi, I have a truenas core system where I replaced all 6 drives in a pool with larger drives. I used the gui to offline and then replace each drive, waiting the 8+ hours each time for the resilvering process to finish. However, when I was done the pool doesn't see the new space and the expand option does nothing. If I look at the drives in the gui, it shows the old size, not the new size. So I opened up the command line and smartctl does show the correct size, but "gpart show" shows just the swap partition and the old disk's size and doesn't show any space available after the partition. Is there a way to get the system to rebuild the partition tables on these drives to get the new larger size?

 

[tod]

I discovered my problem. My HBA is an older Megaraid that is limited to 2TiB drives.