Hi
I've have been trying for the past 5 days or so to improve my transfer speeds and think i've finally narrowed it down to the network card only connecting at 100mb instead of 1gb.
After running "ifconfig -a | grep media" it reports "media: Ethernet autoselect (100baseTX <full-duplex>)". I have tried putting media "1000baseTX mediaopt full-duplex" and "media 1000baseT mediaopt full-duplex" but this just kills the connection and I have to manually reset it again back to default.
When I run "ifconfig -m" supported media comes back as:
media autoselect
media 1000baseT
media 1000baseT mediaopt full-duplex
media 100baseTX mediaopt full-duplex
media 100baseTX
media 10baseT/UTP mediaopt full-duplex
media 10baseT/UTP
I'm a complete noob when it come to linux, i've been searching the forums for days trying to figure this out.
All computers on my network are 1gb, the switch is an unmanaged 1gb switch, the cables are all cat6 which have all been tested with cable tester.
My system is:
motherboard: Intel DH61DL (found here)
Memory: 4gb (I know this is on the low side)
Processor: Intel(R) Celeron(R) CPU G530 @ 2.40GHz.
Freenas: FreeNAS-8.2.0-RELEASE-p1-x64 (r11950)
Anyone have any advice on how to sort this? Sorry is this has already been answered in another post, i 've been looking at tried everything i can find, maybe its something I missed somewhere.
Many thanks.
I've have been trying for the past 5 days or so to improve my transfer speeds and think i've finally narrowed it down to the network card only connecting at 100mb instead of 1gb.
After running "ifconfig -a | grep media" it reports "media: Ethernet autoselect (100baseTX <full-duplex>)". I have tried putting media "1000baseTX mediaopt full-duplex" and "media 1000baseT mediaopt full-duplex" but this just kills the connection and I have to manually reset it again back to default.
When I run "ifconfig -m" supported media comes back as:
media autoselect
media 1000baseT
media 1000baseT mediaopt full-duplex
media 100baseTX mediaopt full-duplex
media 100baseTX
media 10baseT/UTP mediaopt full-duplex
media 10baseT/UTP
I'm a complete noob when it come to linux, i've been searching the forums for days trying to figure this out.
All computers on my network are 1gb, the switch is an unmanaged 1gb switch, the cables are all cat6 which have all been tested with cable tester.
My system is:
motherboard: Intel DH61DL (found here)
Memory: 4gb (I know this is on the low side)
Processor: Intel(R) Celeron(R) CPU G530 @ 2.40GHz.
Freenas: FreeNAS-8.2.0-RELEASE-p1-x64 (r11950)
Anyone have any advice on how to sort this? Sorry is this has already been answered in another post, i 've been looking at tried everything i can find, maybe its something I missed somewhere.
Many thanks.