Incorrect free space after importing zpool

[entr0py]

Hi

I have gone from MacZFS to FreeNAS 9.3, and imported my zpool etc fine (I think). It shows the zpool with the volume in the GUI. However it says it's 100% full and I can't write or delete anything obviously, but it isn't full, and was working fine before exporting and importing the zpool. Tried updating zpool version, to no avail. Can anyone help?


pool: store
state: ONLINE
status: One or more devices are configured to use a non-native block size.
Expect reduced performance.
action: Replace affected devices with devices that support the
configured block size, or migrate data to a properly configured
pool.
scan: scrub repaired 0 in 10h21m with 0 errors on Mon Feb 2 10:21:48 2015
config:

NAME STATE READ WRITE CKSUM
store ONLINE 0 0 0
raidz1-0 ONLINE 0 0 0
gptid/bbde15e4-8286-4aa3-b861-1bf3c51c0172 ONLINE 0 0 0 block size: 512B configured, 4096B native
gptid/5c57f6f7-d48c-44a3-8515-7e605adb3756 ONLINE 0 0 0 block size: 512B configured, 4096B native
ada3p2 ONLINE 0 0 0 block size: 512B configured, 4096B native
ada1p2 ONLINE 0 0 0 block size: 512B configured, 4096B native

NAME SIZE ALLOC FREE EXPANDSZ FRAG CAP DEDUP HEALTH ALTROOT
store 7.28T 7.08T 199G - 55% 97% 1.00x ONLINE /mnt

are the outputs of status and list, anything else that is relevant? I understand the block size issue shouldn't matter other than performance.

Any help would be much appreciated!

 

[cyberjock]

Importing zpools from MacZFS has been known to cause problems. The only option I'm aware of is to create a new pool in FreeNAS and then copy your data to the new pool. Just for the record, all pools used on FreeNAS really should be created in FreeNAS. We've had problems coming from Sun, MacZFS, ZFSonLinux, etc.