Disk attached and then detached

[ibby]

Hello..

First of all guys I am pretty new to freenas / BSD, normally a windows guy.

I have virtulized an installed of freenas setup is;
Server 2012
16 cores 80 GB of ram
some storage presented via LSI raid controllers.

Virtual Machine config is
Current version of Freenas 10.2.
2 virtual network adapters
1 CPU
4 GB of ram
an IDE boot device
an SCSI storage disk.

all disks are vhdx and thin provisioned.

- I understand people do not like virtulised storage solutions but this is only my dev environment at my house and wanted something to be setup so I could play around with it.
-It will eventually be used as NFS and ISCSI


When the Vm is booting I can see the disks being detected and located, once the vm has booted the da1 disk disappears.

If I run dmesg it shows
da1 at storevsc1 etc
da1 msft virtual disk
da1 300mbs
da1 25600mb
da1 msft virtual disk detached.

gpart show only shows one disk

Ideas?
Thanks

 

[pirateghost]

A. Version 10 is in alpha. Don't use it.
B. You haven't given it enough RAM.
C. Hyper-V

 

[Mirfster]

D. Nope, don't do that...

all disks are vhdx and thin provisioned

E. https://forums.freenas.org/index.ph...ative-for-those-seeking-virtualization.26095/
F. Not passing through any controller
G. You are too new to FreeNas to try this TBH

First of all guys I am pretty new to freenas / BSD, normally a windows guy.