Hello, I got new alert, better exchange the harddrive? smartctl -a /dev/da7 smartctl 6.6 2017-11-05 r4594 [FreeBSD 11.1-STABLE amd64] (local build) Copyright (C) 2002-17, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Seagate...

Hello everyone. Below I have a few photos. One of which is my specs that are always asked for. Anyways, I have a hard drive that will NOT format/wipe. I'm new to using FreeNAS (started last August of 2018?) so I am not familiar with all of the shell codes that everyone uses. I try to use the...

Hello all, I've been trying to create a new RAIDZ2 pool with 10 600GB HITACHI DKR5C-J600SS disks, but I have not been able to with 'disk wipe job failed' errors in the GUI. I've run sg_format --size=512 on all the discs, rebooted, and still got the error. I tried running dd if=/dev/zero...

Hello, I have finally updated my H200 card to IT mode and I have also updated my Dell T610 to the latest update pack per the Dell webpage as of August 2018. So, I know I am fully updated. I have installed 6 hard drives and I can only see 5 in FreeNAS. I have done a CAMCONTROL DEVLIST and the...

So, to preface, I have 6x6TB WD Red PRO drives that I bought from ebay and have been trying to do some burn in tests (following this guide) before I integrate them into any kind of zpool and begin putting some data on them. I've done the smartctl short and long tests and all the drives passed...

Hello fellow FreeNazzers, I have a query regarding the replacement of multiple hard drives on my FreeNAS box. I'm familiar with the process having replaced a single drive in the past but I am now getting errors on two drives which is slightly worrying !! Configuration is 10 X 2TB, RAIDZ2...

Hello everyone! I wanted to say thank you to the volunteers that have the "know all" to help us whom do not have that. Awesome! With that said...I have an issue I purchased (4) 4TB hard drives. I did it in batches of 2. I installed the first 2 drives just to test out the system. Learn it and...