Hi - please go easy on an old fella who is rather out of his depth!
I've had 9.2 running happily for many months. Last week I had a couple of power cuts and it resulted in me not being able to log into the Web GUI. I tried resetting the password and somehow I ended up with the following error message(s) on the NAS box screen:
hwpstate0: set freq failed, err 6
hwpstate0: set freq failed, err 6
whence it hangs.
I then decided to update the stick to 9.2.1 which appeared to go fine but the above error still appears.
I have also loaded 9.2.1 as a clean install on a new USB stick and that runs fine with no error. If I try and load my saved 9.2 config then I get an error message. Perhaps my config file got corrupted with the power problem. I guess I'll just need to reload all the settings from scratch, but any suggestions gratefully received.
At least the NAS data is all apparently intact!
I've had 9.2 running happily for many months. Last week I had a couple of power cuts and it resulted in me not being able to log into the Web GUI. I tried resetting the password and somehow I ended up with the following error message(s) on the NAS box screen:
hwpstate0: set freq failed, err 6
hwpstate0: set freq failed, err 6
whence it hangs.
I then decided to update the stick to 9.2.1 which appeared to go fine but the above error still appears.
I have also loaded 9.2.1 as a clean install on a new USB stick and that runs fine with no error. If I try and load my saved 9.2 config then I get an error message. Perhaps my config file got corrupted with the power problem. I guess I'll just need to reload all the settings from scratch, but any suggestions gratefully received.
At least the NAS data is all apparently intact!
