I have a NetApp DS4243 shelf with a lot of hard drives and they all show up with blinky green lights but two drivers are having issues. I use SATA to SAS backplane adapters, and when the drive is dead or disconnected, the adapters show up as devices of 0 bytes and with a throwaway serial number...

Hello everyone. Below I have a few photos. One of which is my specs that are always asked for. Anyways, I have a hard drive that will NOT format/wipe. I'm new to using FreeNAS (started last August of 2018?) so I am not familiar with all of the shell codes that everyone uses. I try to use the...

I have been looking to move into ten gigabit ethernet for some time and final found a workable switch. Another forum member mentioned having issues with vlans on it and I have not seen it on the "Cheap 10gbe Switch" lists so I did a little research. The NetApp CN1610 is a 16 SFP+ port switch...

I have a NetApp DS4243 with 14x 8TB WD Reds connected to a LSI 9201-16e via a QSFP+ to SAS cable inside a Dell PowerEdge R610. Whenever I pull the SMART status for these drives there's only a few values available, temp, power on count. Is it normal to have so little values? Should I be concerned...

Hello! First post. This is likely a BSD kernel issue but I'm pretty new to BSD and not sure how to debug this. Stuff search has pointed me to but not worked: Disable firewire (I dont have firewire) Add the following to /boot/device.hints hint.ata.0.disabled="1" hint.ata.1.disabled="1" This...