Hi Guys,
So I just finished building my computer today, and loaded up FreeNAS as an OS. The general setup completed and then gave me the error that "The web interface could not be accessed." Entering the configure network interface setup, the menu comes up blank.
I am using a B550-F strix MOB. Upon looking around, I saw that it the error comes up sometimes with incompatible hardware (I have no idea why my hardware would be incompatible.... )
I was going to put run Asus XG-C100C (10Gbit) card on it, so I thought that if I could load that up it could solve my problems. It obviously didn't load up natively, but I did find that their were drivers for it that would make it work. A lot of hours later, way to many forums ([HELP] Asus XG-C100C (10Gbit) card : freenas (reddit.com) ), and youtube videos, I haven't been able to compile to code, and even then I am unsure how I would go about transferring it to the NAS in order to make everything magical again.
Any and all help is appreciated!
Best,
D.
So I just finished building my computer today, and loaded up FreeNAS as an OS. The general setup completed and then gave me the error that "The web interface could not be accessed." Entering the configure network interface setup, the menu comes up blank.
I am using a B550-F strix MOB. Upon looking around, I saw that it the error comes up sometimes with incompatible hardware (I have no idea why my hardware would be incompatible.... )
I was going to put run Asus XG-C100C (10Gbit) card on it, so I thought that if I could load that up it could solve my problems. It obviously didn't load up natively, but I did find that their were drivers for it that would make it work. A lot of hours later, way to many forums ([HELP] Asus XG-C100C (10Gbit) card : freenas (reddit.com) ), and youtube videos, I haven't been able to compile to code, and even then I am unsure how I would go about transferring it to the NAS in order to make everything magical again.
Any and all help is appreciated!
Best,
D.