Hello all,
This morning I installed FreeNAS onto a machine that has a disk configuration of 2x Western Digital 2TB Greens using the onboard SATA-II controller (JMB36X) and 1x Western Digital 1TB Blue on the onboard SATA-I controller.
Once installed, when initially going through the FreeNAS setup via my browser, the only disk configuration I was offered was "Auto". I couldn't choose anything else. From the drives it said it was going to format, it seemed to only be interested in the WD 2TB Greens.
Is there a way I can visualise which drives are actually being utilised by FreeNAS and what their configuration (and filesystem) are? I've been reading though the Getting Started documentation but this doesn't seem so clear.
This morning I installed FreeNAS onto a machine that has a disk configuration of 2x Western Digital 2TB Greens using the onboard SATA-II controller (JMB36X) and 1x Western Digital 1TB Blue on the onboard SATA-I controller.
Once installed, when initially going through the FreeNAS setup via my browser, the only disk configuration I was offered was "Auto". I couldn't choose anything else. From the drives it said it was going to format, it seemed to only be interested in the WD 2TB Greens.
Is there a way I can visualise which drives are actually being utilised by FreeNAS and what their configuration (and filesystem) are? I've been reading though the Getting Started documentation but this doesn't seem so clear.