View Disks - No entry Has Been Found

[Peter jam]

New to FreeNAS so forgive my ignorance. I have an HP DL380 G5 server running ESXi 5.0 which I successfully installed FreeNAS on. server has a HP Smart Array 642 SCSI controller connected to an HP MSA20 containing 2 RAID5 Volumes of 3x750GB SATa drives each.
When I get into the Browser and look at storage I see "No entry has been found" for disks.
Do I need to break the RAID5 arrays and create new RAIDX using FreeNAS?
Do I need iSCSI initiator?

 

[zambanini]

zfs and raid is bad.
it need direct access to the disks (smart, error checks)

read the forum posts about virtualization ( mostly bad) and cyberjocks zfs noob guide.

 

[Peter jam]

Zambini,
I was unable to find the suggested guide, I got:
FreeNAS Community - Error
The following members could not be found: cyberjocks.
Can you point me toward that doc please?

 

[cyberjock]

I'm gonna go on a limb and say you haven't done much reading and/or searching for the problem on your own before posting. If you had you'd have likely seen me at least 50 times. I've got more posts than anyone else on the forum....

 

[sremick]

It's in the stickies right at the top of the "New to FreeNAS" board. Really not hard to find... 2 intuitive clicks would get you there, you don't even need to search or type.